How to connect the laser engraving machine to the computer

1、First, we need to connect the power cord to the engraving machine and the power outlet.

2、Next, use the supplied communication cable to connect the engraver to the computer.

3、Turn on the power switch.

4、Mount the engraving knife or drawing pen to the knife holder of the engraving machine.

5、prepare the materials to be engraved, such as reflective film,handheld laser marking machine instant paste, wall stickers, body stickers, stickers, paper, kraft paper and so on.

6、 set the parameters, including the coordinate origin, knife or pen speed, knife or pen pressure and so on. Before you start engraving, please select low speed engraving.

7、Perform test carving operation.

8、The computer will transfer data and start engraving or drawing. The power supply used to connect the power cord is 220 volts AC with a frequency of 50 HZ.When connecting the power supply, first make sure the power switch of the engraver is disconnected.little pecker laser engraver When not in operation, first turn off the power and then pull out the power plug from the socket. Do not plug or unplug the power plug when the power is on. Do not use excessive force when plugging or unplugging the power plug to avoid damaging the connector. After the engraver is turned off, the interval between restarting the starter should not be less than 30 seconds.

9、Connect the serial and parallel cables. Make sure that the power supply of the plotter and the computer are turned off. Connect one end of the parallel cable to the parallel socket of the computer and lock the plug to the socket with the manual locking screw; the other end is connected to the parallel socket of the plotter and the plug socket is securely fastened to the parallel socket with a wire clasp.